Table of Contents
Advertisement
e-STUDIO 16P
Enter Hex Trace Mode
When the printer is in hex trace mode, it prints a hexadecimal and a
character representation of a print job. The printer does not
recognize any print controls or commands in this mode. A hex trace
printout can be used to help isolate the cause of print problems. This
is done by checking the control codes embedded within a print job.
Go to the Special Function Menu (see
following:
1. Select Enter Hex Trace mode by double pressing the operator
panel button until the Paper Jam
2. Perform a long button press until all LEDs are on solid.
The printer is reset to factory defaults.
Hex trace mode can be exited by turning off the printer, or by
pressing and holding the operator panel button to reset the printer.
Print Quality Test Pages
Go to the Special Function Menu (see
following:
1. Select Three Print Quality Test Pages mode by double pressing
the operator panel button until the Ready/Data and Toner Low
LEDs are on.
2. Perform a long button press until all LEDs are on solid.
Jam LED is on.
Print Quality Test Pages mode by double pressing
within a print job.
page
3-11) and perform the
page
3-11) and perform the
Diagnostic Aids
Low
3-21
Advertisement
Table of Contents
