Toshiba e-STUDIO 16P Service Manual page 23

Page printer
Table of Contents

Advertisement

e-STUDIO 16P
Standard Parallel Port Disabled –
This error is generated when the host computer attempts to
communicate with the printer through the standard parallel port,
but the parallel port has been disabled either through the printer
configuration mode, or through the MarkVision™ host utility.
Standard USB Port Disabled –
This error is generated when the host computer attempts to
communicate with the printer through the standard USB port,
but the USB port has been disabled either through the printer
configuration mode, or through the MarkVision host utility.
The error recovery process for this error is:
1. If this error occurs at power–on and an ENA is attached to the
printer, verify the ENA is properly connected.
2. When the printer is in the Ready state, press the operator panel
button to print a menus settings page.
3. Under the "parallel menu", look for the "parallel buffer" line. If
this line says "disabled" and the host computer is trying to print
using the parallel port, re–enable the parallel port using
MarkVision or the printers configuration mode.
4. Under the "USB menu", look for the "USB buffer" line. If this line
says "disabled" and the host computer is trying to print using the
USB port, re–enable the USB port using MarkVision or the
printer configuration mode.
See
"Configuration Mode" on page 3-14
the printer configuration mode to enable a disabled port.
2-6
Service Manual
USB Port Disabled –
B menu", look for the "USB buffer" line. If this line
MarkVision host utility.
A is attached to the
for information on using

Advertisement

Table of Contents
loading

Table of Contents