Table of Contents
Advertisement
Coding Transmitters
Step 18.4 - Code a Transmitter Button for Pet
(Pedestrian) Mode
a.
Briefl y press the DOOR CODE button three times,
then press it again and hold (will beep four times on
fourth press (Fig. 41)).
b.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c.
Release the DOOR CODE button.
d.
Press the transmitter button to test.
e.
To change the default pet (pedestrian) door opening
position, refer Step 2.
Step 18.5 - Coding a Transmitter Button to
the Courtesy Light
The transmitter can be programmed to operate the
courtesy light on the opener independently of the door
moving.
a.
Briefl y press the DOOR CODE button four times,
then press it again and hold (will beep fi ve times on
fi fth press (Fig. 42)).
b.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c.
Release the DOOR CODE button.
d.
Press the transmitter button to test the courtesy
light.
GDO-11v1 SecuraLift ®
Owner Installation Instructions
fi g
41
fi g
42
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GDO-11v1 SecuraLift and is the answer not in the manual?
Questions and answers
garage door motor running but wont open or shut after I manually opened during a power black out
My securalift GDO-11v1 door is not working. I manually opened during a power outage. Now I can hear it running but door not moving. Have re engaged the door with the cord
The Automatic Technology GDO-11v1 SecuraLift garage door motor may still be running but not opening or shutting after manual operation during a power blackout due to a residual charge in the batteries. This can cause the opener to become active even when the main power is off.
This answer is automatically generated