Parameters
Door Status Indicators
Door Opener State
Open
Close
Opening
Closing
Door travel stopped
Door obstructed when opening
Door obstructed when closing
Opener overloaded
Pet Mode Engaged
Mains power interrupted
Button Functions
Buttons
OPERATE
DOOR CODE
FORCE MARGIN SET & OPEN
FORCE MARGIN SET & CLOSE
FORCE MARGIN SET (then) SET
CLOSE (for 6 secs.)
PLUS(+) (for 6 secs.)
SET (then power on) & hold until all LEDs are off
DOOR CODE (then power on) & hold until all LEDs
are off
SET & DOOR CODE (the power on) and hold until all
LEDs are off
SET
GDO-11v1 SecuraLift ®
30
OPEN LED (Green)
On
Flashing
Flashing
Flashing
Alternating fl ashes
On
Rapid fl ashes
Owner Installation Instructions
CLOSE LED (Red)
Beeper
On
Flashing
Flashing
Flashing
Beeps as door moves
Alternating fl ashes
On
Function
Opens/Stops/Closes the door
Codes a transmitter button for operate function,
Vacation function, Auxilary function, Pet mode and
Light function
Increases the obstruction force margin setting
Decreases the obstruction force margin setting
Resets the factory default force margin settings
Clears the door limits set positions. Limits then
need to be reset
Enters pet (pedestrian) position mode
Deletes control parameters excluding transmitter
storage memory
Deletes all transmitter storage memory
Deletes all control parameters and transmitter
storage memory.
Re-initialises the Opener to re-calculate force
margin
Need help?
Do you have a question about the GDO-11v1 SecuraLift and is the answer not in the manual?