Table of Contents
Advertisement
Knockdown C-Rail Assembly
Step 1 - Knockdown C-Rail Assembly
Note: If your opener came with a one piece track,
proceed to Assembly step 2, page 13.
a.
Place track pieces on fl at surface for assembly. All
the track sections are interchangeable.
b.
Slide sleeve onto the track section (Fig. 05). Connect
track by sliding sleeve onto next track section. Tap
track assembly on piece of wood until track sections
are fl ush. Repeat with remaining track sections.
c.
Remove chain from package and lay chain out on
fl oor (do not allow chain to twist).
d.
Loop the chain onto the pulley of tension chain
assembly. Slide the tension chain assembly with
chain into the track (Fig. 06).
e.
Slide shuttle assembly into (opener end) the track
assembly, be sure to insert shuttle assembly with
hole side toward the door as shown with arrow in
(Fig. 07). Push the sprocket support into (opener
end) of the track.
f.
Feed the chain through the shuttle assembly then
through the sprocket support and loop around
the sprocket then feed back through the sprocket
support and shuttle assembly. Join to chain index
with chain links ( supplied ) (Fig. 07).
Idler pulley
Shuttle with hole side toward the door
GDO-11v1 SecuraLift ®
Owner Installation Instructions
fi g
05
fi g
06
fi g
07
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GDO-11v1 SecuraLift and is the answer not in the manual?
Questions and answers
garage door motor running but wont open or shut after I manually opened during a power black out
My securalift GDO-11v1 door is not working. I manually opened during a power outage. Now I can hear it running but door not moving. Have re engaged the door with the cord
The Automatic Technology GDO-11v1 SecuraLift garage door motor may still be running but not opening or shutting after manual operation during a power blackout due to a residual charge in the batteries. This can cause the opener to become active even when the main power is off.
This answer is automatically generated