16. Setting Courtesy Light Time; Setting Pet Mode Door Opening Position; Resetting Factory Defaults - Automatic Technology GDO-6 v2 Slim-Drive EasyRoller Installation Instructions Manual

NOTE: Remove the control panel cover for access.
Remember to replace the cover when set up is complete.

16. SETTING COURTESY LIGHT TIME

The preset courtesy light time on the door opener is 3
minutes. This time can be changed by the following:
1. Press and hold both the Auto Close Time button and Force
Margin Set buttons (Fig. 25).
2. While holding the two buttons, press Open button. Each
press will add 10 seconds to the light time.
3. To decrease the time follow Step 1 and press the Close
button. Each press will deduct 10 seconds from the light
time.
4. To recall the factory set default light time press in and hold
together the Auto Close Time button, the Force Margin Set
button and the Set button for about 2 seconds. Release all
buttons, the factory set default of 3 minutes will be recalled.
17. SETTING THE PET MODE DOOR
OPENING POSITION.
The default Pet (Pedestrian) position is about 1/4 turn of the
door drum above the closed position. The pet mode status is
indicated by both the Open and Close Limit LED's being
illuminated. The default position can be changed by the
following:
1. Make sure the door is in the closed position. Press and hold
the Open button for six (6) seconds (Fig. 26), you should
hear three beeps and the Open and Close LEDs will flash
rapidly.
2. Press the Open or Close buttons to move the door to your
required new pet open position.
3. Press the Set button to record the new position.
The pet mode is activated from a transmitter button coded to
that function (see Step 10.3 on page 15). When activated the
door drives to the preset position from either above or below. If
the pet button is pressed while the door is moving the door will
be stopped. If the pet button is pressed when the door is in the
pet position, then the door will be closed. No auto close is
enabled.
18. INSTALLATION OF WALL MOUNTED
TRANSMITTER HOLDER
1. Mount the holder in a location out of reach of children (at
least 1.5m from the floor) and convenient to the customer.
Make sure the door is visible from this location.
2. The transmitter can be easily clipped in and removed from
the holder as required.
3. To set the transmitter codes refer to Step 10.
19. RESET ALL FACTORY DEFAULTS
1. Turn power off.
2. Press and hold Set button.
3. Turn power on and continue holding Set until all LEDs are
off.
Note: This does not erase transmitter codes stored in memory.
FINAL SET UP
20. RE-INITIALISING THE OPENER
To re-initialise the opener press and hold the Set Button for two (2)
seconds, the beeper will sound once. The door will start to move
and re-calculate force margins. The door can move between the
open and close limit positions up to four (4) times (depending on
the position of the door and the power up condition). A single beep
will be heard once the initialisation is complete. The door is now
ready for use.
18
FIG. 25
FIG. 26
FIG. 27