Coding Transmitters; Door; Vacation Mode - Automatic Technology GDO-11v1 SecuraLift User Manual

Coding Transmitters

fi g 38
fi g 39
fi g 40
GDO-11v1 SecuraLift ®
22
Step 18.1 - Code a Transmitter Button for
Door Operation
Step 18.2 - Code a Transmitter Button to
Enable Vacation mode
The opener can be programmed into a "Vacation
Mode" where the opener will not respond to any
transmitter except the button of the transmitter the one
programmed for vacation mode.
Step 18.3 - Code a Transmitter Button to
Enable AUX OUTPUT
Owner Installation Instructions
a. Press and hold the DOOR CODE button (Fig. 38).
b. Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c. Release the DOOR CODE BUTTON.
d. Press the transmitter button to test.
a. Briefl y press the DOOR CODE button once, then
press it again and hold (will beep two times on
second press (Fig. 39)).
b. Press one of the four (4) buttons on the transmitter
for two (2) seconds, pause for two (2) seconds,
then press the same button again for two (2)
seconds.
c. Release DOOR CODE button.
d. Press and hold the transmitter button for six (6)
seconds to set Vacation Mode. the door code led
will stay lit while vacation mode is active.
e. To reset Vacation Mode press the same button
for two seconds.
a. Briefl y press the DOOR CODE button two (2)
times, then press it again and hold (will beep
three times on third press (Fig. 40)).
b. Press one of the four buttons on the transmitter
for two (2) seconds, pause for two (2) seconds,
then press the same button again for two (2)
second.
c. Release the DOOR CODE button.
d. Press the transmitter button to test.