Powering On The System - Brocade Communications Systems ICX 6430 Hardware Installation Manual

4. Connect one end of the AC cord to the AC receptacle on the external power supply, and the other
end to a grounded power outlet.
5. Check the LEDs on the external power supply to ensure proper operation with the devices. On the
ICX 6400-EPS1500, the LED indicators (EPS 1, EPS 2, and EPS 3) should light (green). If the
LEDs do not light, refer to
FIGURE 50 Connecting multiple devices to an external power supply
NOTE
For international use, you may need to change the AC line cord. You must use a line cord set that
has been approved for the receptacle type in your country.

Powering on the system

After you complete the physical installation, you can power on the system.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01
Diagnosing switch indicators
1 EPS Input port on the ICX 6430 or ICX 6450 device
2 ICX 6430 and ICX 6450 devices
3 AC power supplies for ICX 6430 or ICX 6450 devices.

Powering on the system

on page 97.
4 AC power supply for ICX 6400-EPS1500
5 ICX 6400-EPS1500
6 Output port of the ICX 6400-EPS1500
61