Features And Benefits - Brocade Communications Systems ICX 6430 Hardware Installation Manual

Features and benefits

the maximum number of PoE or PoE+ ports of the internal power supply capability of each ICX 6430
or ICX 6450 device.
For more information about the maximum number of PoE or PoE+ ports supported with the internal
power supply of a device, refer to the
6450_48P device with two EPS connectors must be connected to the ICX 6400-EPS1500. If you
increase the maximum number of PoE or PoE+ ports that can be supported in each ICX 6430 or ICX
6450 device, and if the internal power supply fails, the ICX 6400-EPS1500 cannot guarantee the
devices are protected by the backup power source. The ICX 6400-EPS1500 will not have enough
power to sustain the failed internal power supply. In this case, the device can go down even with the
ICX 6400-EPS1500 connected.
The ICX 6400-EPS1500 has three DC output ports: EPS OUT 1, EPS OUT 2, and EPS OUT 3. Each
port supplies 65 W of +12 VDC of DC power, and 370 W of 54 VDC of PoE power. The ICX 6400-
EPS1500 is powered on when it is connected to an active AC power source.
NOTE
The ICX 6400-EPS1500 DC cable is hot-pluggable. You must pay attention to the PoE power usage to
ensure that the devices are protected before removing the EPS connectors or AC power cords.
The following devices are supported by the BrocadeICX 6400-EPS1500:
•
•
•
•
•
•
•
NOTE
The ICX 6430-24P is not supported by the ICX 6400-EPS1500.
Features and benefits
•
•
•
•
•
•
•
•
•
•
•
•
48
ICX 6430-24P
ICX 6430-48
ICX 6430-48P
ICX 6450-24
ICX 6450-24P
ICX 6450-48
ICX 6450_48P
Supports up to three connections to ICX 6430 and ICX 6450 devices.
Fixed internal power supply.
Total power rating is 1500 W.
Status LEDs located on the front panel.
Universal (100-240 V) AC line cord draws power from power outlet.
DC line cord provides power to the attached device.
Thermal overload protection prevents the ICX 6400-EPS1500 from overheating if a thermal
overload occurs.
Over-voltage protection shuts down an output channel if the voltage exceeds a preset threshold.
Over-current protection shuts down the ICX 6400-EPS1500 if the output load exceeds a preset
threshold.
Short-circuit protection prevents damage to the ICX 6400-EPS1500 due to a short circuit on any
output channel.
If an ICX 6430 or ICX 6450 device is not connected to an EPS port, the power will not come up.
Power supplies are hot swappable. The device can be running while the ICX 6430 or ICX 6450
units are connected to the ICX 6400-EPS1500.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
Power supply usage on page 22 section. For example, an ICX
53-1003079-01