Brocade Communications Systems ICX 6430 Hardware Installation Manual page 30

ICX 6430 and ICX 6450 Installation
NOTE
You need a #2 Phillips screwdriver for rack mount installation.
Complete the following steps to mount devices in rack.
1.
2.
3.
4.
5.
28
Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
brackets and six sink-head screws.
Using a Phillips screwdriver, attach the mounting brackets to the sides of the device using six
sink-head screws.
FIGURE 22 Attaching the mounting brackets for ICX 6430 and ICX 6450 devices
Remove the two-post rack kit from the shipping carton. The kit contains four rack-mounting
screws and four cage nuts.
Insert the cage nuts in the two-post rack where you want to mount the device.
Using a Phillips screwdriver, mount the device in a two-post rack using four rack-mounting
screws.
NOTE
The ICX 6430 and ICX 6450 devices must be installed on 2-post racks only. The devices cannot
be installed on 4-post racks.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01