Unpacking A System; Powering On The System - Brocade Communications Systems FastIron SuperX Hardware Installation Manual

Fastiron x series
Hide thumbs Also See for FastIron SuperX:
Table of Contents

Advertisement

2

Unpacking a system

TABLE 15
Task Number
6
7
8
9
10
Unpacking a system
The FastIron X Series ships with several items. Please review the list below and verify the contents:
NOTE
If any items are missing, please contact the place of purchase.
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.
42
FSX hardware installation tasks (Continued)
Task
The chassis ships with a slot panel installed in all
module slots that do not currently have a module
installed. If you plan to install a module in a slot, you
must remove the slot panel.
CAUTION: If you do not install a module in a slot, you
must keep the slot panel in place. If you run the
chassis with an uncovered slot, the system will
overheat.
Install the management module and interface
modules in the chassis
Attach a management station to the management
module's serial (Console) port or a 10/100/1000
Ethernet port.
Power on the AC power supplies.
After the chassis is powered on, observe the LEDs or
display the status of the modules using the CLI to
determine that the chassis is operating properly.
FSX or FSX 800, or FSX 1600 chassis with the following installed:
one or two 12-volt power supplies
fan tray assembly or assemblies
slot panels installed in all unoccupied slots
The FSX 800 and FSX 1600 also come with two switch fabric modules already installed
Rack Mount Kit (FSX 1600 models only)
Management module or modules (packaged separately)
Optional interface modules (packaged separately)
Warranty card
A 115V AC power cable for each AC power supply you purchase from Brocade
Where to Find More Information
"Removing the slot panels"
"Installing the management and interface
modules"
"Attaching a management station"
page 56

"Powering on the system"

"Verifying proper operation"
Brocade FastIron X Series Chassis Hardware Installation Guide
on page 50
on page 51
on
on page 58
on page 63
53-1001723-02

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fastiron sx 1600Fsx 1600Fastiron sx 1600 acoustic noise-reducedFsx 1600-anrFsxFastiron sx 800 ... Show all

Table of Contents