Cable Specifications; Power Cords - Brocade Communications Systems ICX 6430 Hardware Installation Manual

TABLE 23
Pin number
1
2
3
4
5
6
7
8

Cable specifications

For information about supported transceivers and cable lengths and types, refer to the following
Brocade website at:
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.pdf
NOTE
Cable installation and network configuration affects overall transmission capability. For network-specific
recommendations, consult your local Brocade reseller or system engineer.

Power cords

NOTE
Brocade recommends that you use the power cord that is shipped with the device.
For the ICX 6430 and ICX 6450 devices to operate at 100V, the power cord should be C13 type
connector with 13A rating or better (NEMA-5-15 plug)
For the ICX 6430 and ICX 6450 devices to operate at 240V, the power cord should be C13 type
connector with 10A rating or better.
For the ICX 6400-EPS1500 to operate at 100V, the power cord should be C19 type connector with 20A
rating or better (NEMA5-20P plug)
For the ICX 6400-EPS1500 to operate at 240V, the power cord should be C19 type connector with 13A
or better.
All devices ship with United States compatible power cords unless otherwise specified at the time of
order. United Kingdom- and European-compatible power cords are also available.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01
Console serial RJ45 management port pinouts
Definition
NC
NC
UART0_TX
GND
GND
UART0_RX
NC
NC
Cable specifications
Notes
Console Port
Console Port
95