Check Points Of Initial 50 Hours - Kubota WSM M8540 Workshop Manual

M8540, M9540, WSM

[2] CHECK POINTS OF INITIAL 50 HOURS

Adjusting Clutch Pedal (Synchro Shuttle Model)
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and measure free travel at the
top of pedal stroke.
3. [ROPS model]
If adjustment is needed, loosen the lock nut (1) and turn the
turnbuckle (2) to adjust the rod length within acceptable limits.
[CABIN model]
If adjustment is needed, loosen the lock nut (1) and to adjust the
cable length within acceptable limits.
4. Retighten the lock nut (1).
Proper clutch pedal free
Factory spec.
travel (L)
(1) Lock Nut
(2) Turnbuckle
(3) Cable
Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plugs (2) at the bottom of
the engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the upper notch on the dipstick.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" in this
section.)
Oil capacity with filter
(1) Oil Inlet
(2) Drain Plugs
G-18
G GENERAL
40 to 50 mm
1.6 to 2.0 in.
L : Free Travel
[A] ROPS Model
[B] CABIN Model
W1066699
10.7 L
11.3 U.S.qts
9.4 Imp.qts
(A) Oil level is acceptable within this
range.
W1021565
KiSC issued 03, 2009 A