Problems With No Fault Display - WMF 1000 User Manual

Messages and Tips
EEPROM Error
Motor driver error
Grinder blocked
Temperature sensor
steam
Temperature sensor water
Timeout level
5

Problems with no fault display

Error
No milk foam/milk output,
but milk in reservoir
No milk foam,
only hot milk
Milk or milk foam
is too cold
> Switch machine on/off
If the error repeats, the fault must be eliminated by the WMF 1000
Service-Center.
> Switch machine on/off
If the error repeats, the fault must be eliminated by the WMF 1000
Service-Center.
The grinders are blocked by foreign bodies:
To eliminate, see section "Manual cleaning"
> Clean bean hopper; switch-off machine, turn grinders clockwise
with the multitool in order to be able to remove foreign bodies
Grinding degree too fine:
> Set grinding degree coarser
> Switch-off coffee machine, allow to cool and switch-on again
If the error repeats, the fault must be eliminated by the WMF 1000
Service-Center.
Air in the system, possibly associated with loud pump noise:
> Check whether the water tank is pushed in completely
> Take milk hose out of the milk container and press the milk foam
button
If hot water comes out instead of steam:
> Carry out descaling
If steam comes out:
> Please call the hotline
Action
> Check that milk hose is not kinked or crimped, lay milk hose
again
> Clean all-in-one spout and milk nozzle
> Put milk lever in milk foam position
> Carry out foamer rinse, pushing spout completely upwards
> If necessary, check whether the air intake nozzle of the all-in-
one spout is stopped up
> Ensure that the milk nozzle is on the milk hose
> Check whether the correct milk nozzle is mounted
> (transparent for refrigerated milk)
See See
chapter WMF 1000 Service-Center chapter WMF 1000 Service-Center
See See
chapter other settings chapter other settings
See See
chapter Care > chapter Care >
cleaning the milk system cleaning the milk system