Table of Contents
Advertisement
Care
Care program, general
When switching the machine on and off, an automatic coffee system rinse starts automatically.
This requires that there always sufficient water in the water tank (200 ml per rinse).
The rinse water is caught in the drip tray. Empty the drip tray regularly or place a container (min.
200 ml) under the all-in-one spout during the rinse.
After each brewing cycle, in the heating up phase and during the care programs, so-called
release water runs into the drip tray. This rinses any remaining coffee from the pipes. This is a
completely normal procedure and not an error in the coffee machine.
Run the care program regularly, and without delay when the request to do so
appears in the display. WMF assumes no liability for damage due to lack of cleaning
or descaling or due to the use of other cleaning or descaling agents than those
provided by WMF. All guarantee and warranty claims then lapse.
Cleaning and descaling agents are irritants and during execution of the programs,
they become very hot. Avoid any contact with these liquids. The plastic parts of the
coffee machine may not come into contact with the descaling agent.
Heed the instructions on the packaging and in the Safety chapter.
3
Calling up the care programs
To select the care programs without a previous request on the display:
>
Press the
P button
>
Use the care button to browse to the desired program
>
Select the displayed program with the
select care program
select care program
browse: care button
browse: care button
P button
Advertisement
Table of Contents
