WMF 1000 User Manual page 57

Milk is too hot and there is Milk is too warm:
too little or >
milk foam has bubbles >
>
>
>
Leakage:
>
>
All-in-one spout: >
Assembly/disassembly
The grease for sealing rings is in the accessories box.
is stiff
Water tank stiff >
Display side doors open >
Pump makes loud noises Water tank is not inserted correctly (air in the system).
>
>
>
Hint: it is normal if during operation the water pump runs indepen-
dently from time to time; it fills the system automatically.
Coffee has no creme •
•
•
•
•
Brewing unit can no Brewing unit is not in the basic setting
longer be pulled out or >
inserted >
Refrigerate milk
Check that milk hose is not kinked or crimped
Lay milk hose again
Check whether the correct milk nozzle is mounted
(grey for unrefrigerated milk)
Check all connections and seals of the all-in-one spout
Milk lever is not all the way up for milk foam or not all the way
down for milk
Lightly smear O-rings with WMF sealing grease and make sure
that no grease gets into the air intake opening
Lightly smear O-rings with WMF sealing grease
Brewing unit is not inserted correctly or doors are not closed
correctly - check! The lever labeled "Press" must always be in
the level position.
Push in water tank completely
Bleed machine:
Dispense hot water until a constant stream of water comes out
Unsuitable coffee mixture or coffee is not fresh
Quantity of ground coffee is set too low
Cups too cold: pre-warm
Brewing temperature too low: increase temperature
Grinding degree too coarse: set grinding degree finer
Close the right side door and switch machine on
The brewing unit can be adjusted using the multitool until the
brewer can be inserted
Messages and Tips
Brewing temperature Brewing temperature
See chapter settings See chapter settings
> basic settings > basic settings
Grinding degree Grinding degree
See chapter other settings See chapter other settings
55