Table of Contents
Advertisement
Error messages and faults
Essential procedure in case of error messages or faults:
Switch coffee machine off and then on again after a few seconds. Repeat the process which
caused the fault. In many cases, this eliminates the fault and you can continue working.
If this is not successful:
Search in the error list for the error message and follow the instructions.
If this is not successful or the error displayed is not listed, please call the WMF service hotline!
Some messages lead to blocking of individual functions. You will notice this by the fact that the
beverage button light goes out. The beverage buttons which are still illuminated can continue to
be served.
Fault messages on the display
Error message
Action
Use brewer
Brewer is not used:
Use brewer
Brewer end switch
Brewer unit not inserted correctly:
>
Brewing unit stiff:
>
Flow fault
>
(water tank is empty)
>
Flow fault
Air in the system, possibly associated with loud pump noise:
(water tank is full)
>
>
No hot water dispensing:
>
Brewing unit stopped up:
>
If the error occurs sporadically:
>
>
Use brewing unit correctly
Remove brewer, open brewing chamber with multitool, apply a
thin layer of the grease from the accessories kit to the red seal
ring
Check to make sure that float in the water tank runs smoothly
and fill water tank
Bleed machine: Dispense hot water until a constant stream of
water comes out
Check whether the water tank is pushed in completely
Bleed machine: Dispense hot water until a constant stream of
water comes out
Remove water filter/dirt trap from tank, try again
Remove brewing unit, clean manually, insert and carry out
cleaning program
Set grinding degree coarser
Switch-off pre-brew
Messages and Tips
See chapter Care > water tank
See chapter Care > water tank
Clean brewing unit, see chapter Care
Clean brewing unit, see chapter Care
> Brewing unit
> Brewing unit
Set grinding degree
Set grinding degree
see chapter other settings
see chapter other settings
53
Advertisement
Table of Contents
