Removing And Installing The Removable Compact Flash Disk - Juniper J2300 Getting Started Manual

4.
5.
6.
7.
8.
9.
10.
Figure 59: Installing the Primary Compact Flash Disk

Removing and Installing the Removable Compact Flash Disk

The removable compact flash disk is an optional component on J4300 and J6300
Services Routers. The removable compact flash disk provides secondary storage
for the router. It can accommodate software images, configuration files, and
microcode. If the primary compact flash disk fails on startup, the router boots
from the removable compact flash disk.
For information about configuring the removable compact flash disk, see the
J-series Services Router Administration Guide.
To remove and install a removable compact flash disk, perform the following
procedures:
Loosen the thumbscrew that secures the primary compact flash drive cover
on the rear of the chassis.
Remove the compact flash drive cover.
Slide the compact flash disk into the connector on the Routing Engine (see
Figure 59).
Replace the compact flash drive cover.
Tighten the thumbscrew that secures the compact flash drive cover to the
rear of the chassis.
Plug the power cord into the power supply.
Press and release the power button to power on the router. Verify that the
LED lights steadily after you press the power button.
POWER
Removing the Removable Compact Flash Disk on page 172
Installing the Removable Compact Flash Disk on page 173
Replacing and Troubleshooting Hardware Components
Replacing Hardware Components
171