Dual-Port Fast Ethernet Pim - Juniper J2300 Getting Started Manual

Table 31: Status LEDs for T3 and E3 Ports (continued)

Dual-Port Fast Ethernet PIM

The Dual-Port 10/100-Mbps Fast Ethernet PIM (Figure 30) has two
physical Fast Ethernet ports.
Figure 30: Fast Ethernet PIM
The Dual-Port Fast Ethernet PIM provides the following key features:
For pinouts of cable connectors for Fast Ethernet PIMs, see "RJ-45 Connector
Pinout for Fast Ethernet Ports" on page 210.
For alarms, see the configuring and monitoring alarms information in
the J-series Services Router Administration Guide.
For installing and removing a PIM, see "Replacing a PIM" on page 164.
Color State
Yellow On steadily
Unlit Off
Onboard network processor
Full-duplex and half-duplex modes
Media access control (MAC) address filtering
Autonegotiation through medium-dependent interface (MDI) and MDI
crossover (MDI–X) support
Physical Interface Modules Overview
Description
Loopback mode.
T3 (DS3)—Remote endpoint is in
red alarm failure.
E3—Remote defect indication
(RDI).
Offline.
Field-Replaceable PIMs
57