For pinouts of cable connectors for T1 and E1 PIMs, see "E1 and T1
RJ-48 Cable Pinouts" on page 211.
For alarms, see the configuring and monitoring alarms information in
the J-series Services Router Administration Guide.
For installing and removing a PIM, see "Replacing a PIM" on page 164.
Status LEDs indicate port status. Table 29 describes the meaning of the LED states.
Table 29: Status LEDs for T1 and E1 Ports
Dual-Port Channelized T1 or E1 PIM
The Dual-Port Channelized T1 or E1 PIM (Figure 27) is a multiflex interface card
that allows you to configure a single interface as a channelized T1 interface or a
channelized E1 interface. The channelized T1 or E1 interface supports up to 24 DS0
channels on a T1 interface and up to 32 DS0 channels on an E1 interface, in addition
to supporting the features of regular (unchannelized) T1 and E1 PIMs. Each interface
can be configured as a single clear channel, fractionalized, or channelized interface.
NOTE: You cannot configure a channelized T1 or E1 interface through a J-Web Quick
Configuration page.
G.703, G.704, and G.706 E1 standards compliance
Independent internal and external clocking system
Loopback, bit error rate test (BERT), T1 facilities data link (FDL), and long
buildout diagnostics
Color
State
Green
On steadily
Red
On steadily
Unlit
Off
Physical Interface Modules Overview
Description
Online with no alarms or failures.
Active with a local alarm. The router has
detected a failure.
Offline.
Field-Replaceable PIMs
53