Installing The Primary Compact Flash Disk - Juniper J2300 Getting Started Manual

J2300, J4300, and J6300 Services Router Getting Started Guide
3.
4.
5.
6.
7.
8.
Figure 58: Removing the Primary Compact Flash Disk

Installing the Primary Compact Flash Disk

To install the primary compact flash disk (see Figure 59):
NOTE: If you plan to boot the Services Router from the primary compact flash disk,
you must first configure the primary compact flash disk in another router or with
a computer running UNIX or Cygwin. For more information, see the J-series
Services Router Administration Guide.
1.
2.
3.
170
Replacing Hardware Components
the router is disconnected from earth ground. For more information about
ESD, see the Getting Started Guide for your model.
Press and release the power button to power off the router. Wait for the
LED to turn off.
POWER
Remove the power cord from the power supply.
Loosen the thumbscrew that secures the primary compact flash drive cover
on the rear of the chassis.
Remove the compact flash drive cover.
Gently grasp the compact flash disk, and slide it out of the connector (see
Figure 58).
Place the compact flash disk on the antistatic mat or in the electrostatic bag.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about
ESD, see the Getting Started Guide for your model.
Press and release the power button to power off the router. Wait for the
LED to turn off.
POWER
Remove the power cord from the power supply.