Unpacking A J-Series Services Router - Juniper J2300 Getting Started Manual

J2300, J4300, and J6300 Services Router Getting Started Guide
Table 45: Equipment and Tools Required for Services Router Installation
Desk Installation—J2300
Services Router Only
Rubber feet (provided)
NOTE: The AC power cord for the Services Router is intended for use with the
router only and not for any other use.

Unpacking a J-series Services Router

The Services Router is shipped in a cardboard carton and secured with foam packing
material. The carton also contains an accessory box and quick start instructions.
NOTE: The router is maximally protected inside the shipping carton. Do not unpack
it until you are ready to begin installation.
To unpack the router:
1.
96
Unpacking a J-series Services Router
Wall Installation—J2300 Services
Router Only
Rubber feet (provided)
Mounting brackets and screws
(provided)
Number 2 Phillips screwdriver
Four wall screws or four
mounting screws and anchors
capable of supporting the full
weight of the chassis, up to
12 lb (5.4 kg)
For installation, gather the following equipment and tools: mounting brackets
and screws (provided), number 2 Phillips screwdriver, and mounting screws
appropriate for your rack.
To connect the router to power and ground, have ready a 14 AWG grounding
cable and lug, as specified in "Chassis Grounding" on page 101, and the power
cords or cords shipped with the router. (You must supply your own power
cables if you have a DC-powered router.)
To connect network interfaces, have ready a length of cable used by the
interface, as specified in "Network Cable Specifications and Connector
Pinouts" on page 201.
If your router has ISDN ports, you might need an NT1 device to connect to the
ISDN service. For details, see "ISDN Provisioning" on page 94.
Move the shipping carton to a staging area as close to the installation site as
possible, but where you have enough room to remove the router.
Rack Installation
Mounting brackets and screws
(provided)
Number 2 Phillips screwdriver
Four (J2300) or eight (J4300
and J6300) mounting screws
appropriate for your rack