For pinouts of cable connectors for the network ports, see "Network Cable
Specifications and Connector Pinouts" on page 201.
For alarms, see configuring and monitoring alarms information in the
J-series Services Router Administration Guide.
Table 17 describes the meaning of the LEDs for a Fast Ethernet port, and Table 24
describes the meaning of the status LED for a G.SHDSL port.
Table 24: Status LED for G.SHDSL Ports
Dual-Port G.SHDSL with ISDN BRI S/T Chassis
The J2300 Dual-Port G.SHDSL with ISDN BRI chassis has two Fast Ethernet LAN
ports, two G.SHDSL WAN ports, and one ISDN BRI S/T port as shown in Figure 23.
The G.SHDSL ports provide symmetric high-speed digital subscriber line (SHDSL)
interfaces to ATM network media for ATM-over-SHDSL connections. The ISDN
BRI S/T interface is the backup interface to the primary G.SHDSL interface and
provides ISDN failover support for a G.SHDSL connection.
Programmable line rates in both modes:
2-port two-wire mode supports autodetection of line rate and fixed line
rates from 192 Kbps to 2.304 Mbps in 64-Kbps increments.
1-port four-wire mode supports fixed line rates from 384 Kbps to
4.608 Mbps in 128-Kbps increments.
Up to 16 virtual channels (VCs) per G.SHDSL port
ATM-over-G.SHDSL framing
"Dying gasp" notification
Local and remote loopback diagnostics
ITU-T G.991.2, ITU-T G.994.1, and ITU-T G.997.1 standards compliance
Color
State
Green
On steadily
Red
On steadily
Physical Interface Modules Overview
Description
Online with no alarms or failures.
Active with a local alarm. The router has detected
a failure.
J2300 Chassis with Fixed PIMs
47