Alarm Led; Power Button And Power Led - Juniper J2300 Getting Started Manual

Table 7: Juniper Networks Logo LED

ALARM LED

The
Figure 5). The yellow (amber) LED lights to indicate a critical condition that can
result in a system shutdown or a less severe condition that requires monitoring
or maintenance. When the condition is corrected, the light turns off.
NOTE: The
condition is major (red) or minor (yellow).
To deactivate alarms, you must clear the condition that caused the alarm. For a list
of alarms that can occur on the router, see "Chassis Alarm Conditions" on page 188.

Power Button and POWER LED

The power button is located on the left side of the front panel (see
Figure 5). You can use the power button to power the Services Router
on and off. When you power on the router, the Routing Engine boots as
the power supply completes its startup sequence.
The
panel. Table 8 describes the
Color
Blue
LED is located to the left of the power button on the front panel (see
ALARM
LED on the Services Router lights yellow whether the alarm
ALARM
LED is located to the left of the power button on the front
POWER
State
Off
On steadily
Blinking
LED.
POWER
J2300 Services Router Hardware Features
System Overview
Description
Router is unplugged, powered
off, or malfunctioning.
Router is functioning
normally.
Router is booting and
not yet forwarding
traffic.
Or
Router is operating
but unable to forward
traffic because of a
problem.
For a list of alarms that can
occur on the router, see
"Chassis Alarm Conditions"
on page 188.
15