Replacing The Console Port Cable; Replacing A Pim; Removing A Pim - Juniper J2300 Getting Started Manual

J2300, J4300, and J6300 Services Router Getting Started Guide
Table 57: Tools and Parts Required
Tool or Part
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD)
grounding wrist strap
Flat-blade screwdriver,
approximately 1/4 in. (6 mm)
Phillips (+) screwdriver, number 2

Replacing the Console Port Cable

The RJ-45 port labeled
you to connect the router to an external management device, such as a
laptop or a terminal server. For cable specifications, see "Network Cable
Specifications and Connector Pinouts" on page 201.
To replace the console port cable:
1.
2.
3.

Replacing a PIM

To remove or install field-replaceable Physical Interface Modules (PIMs) in a
Services Router, you must first power off the router. This section contains the
following topics:

Removing a PIM

The PIMs are installed in the front of the Services Router. A PIM
weighs less than 1 lb (0.5 kg).
164
Replacing Hardware Components
Components
All
All
PIM
Compact flash
DRAM modules
Power system components
CONSOLE
Locate an appropriate replacement cable and connector.
Plug the Ethernet connector at either end of the cable into the console port
on the front panel (see Figure 52 and Figure 53).
Plug the connector at the other end of the cable into the external management
device. If you are connecting to a DB-9 serial port, use the provided RJ-45
to DB-9 serial port adapter.
Removing a PIM on page 164
Installing a PIM on page 166
on the Services Router's front panel allows