Blackdiamond 8806 Ac Power Cord Retainer Channel; Installing The Blackdiamond 8806 Ac Power Cord Retainer Channel - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

BlackDiamond AC Power Cord Retaining Brackets

BlackDiamond 8806 AC Power Cord Retainer Channel

Connect all AC power cords before you install the power cord retaining bracket.
You need the following tools and equipment before installing or removing the BlackDiamond 8806 AC
power cord retainer channel:
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
Installing the BlackDiamond 8806 AC Power Cord Retainer
Channel
To install the BlackDiamond 8806 AC power cord retainer channel:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top-left corner of the switch front panel.
2 Starting at the left, insert the plug of each AC power cord into the power connectors on the switch,
and lift each installed power cord over the previous plug (see
Verify that all installed AC power cords are firmly plugged into the power connectors.
Figure 82: Installing and Routing the AC Power Cords
128
Starting at the left, insert each plug
and lift power cord over previous plug
Figure 82).
EX_138
BlackDiamond 8800 Series Switches Hardware Installation Guide