Vertical Adjustment Of The Headlight Beam - APRILIA RSV 1000 R Factory Use And Maintenance Book

VERTICAL ADJUSTMENT OF THE
HEADLIGHT BEAM
NOTE
Beam inspection procedures may
vary from country to country. Observe the
law in force in the country of the user.
To set beam height:
◆
Place the vehicle on the stand, see page
60 (PLACING THE VEHICLE ON THE
STAND).
◆
Working from the rear left side of the
front fairing, fit a short cross-headed
screwdriver to the adjuster screw (1) and
adjust as follows:
√ TIGHTEN (clockwise) to raise the beam;
√ SLACKEN (anticlockwise) to lower the
beam.
◆
Repeat process for the right beam.
2
When finished:
WARNING
Check for proper beam height setting.
CAUTION
The headlights are also fitted with
adjuster screws (2) for horizontal beam
adjustment.
Correct beam horizontal adjustment is
performed at the factory and we advise
against disturbing standard setting,
unless such adjustment is mandatory in
your country.
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
1
105