Removing And Installing Abs Relay And Relay Base; Removing Abs Relay; Installing The Abs Relay - BMW R 1100 RT Repair Manual

Removing and installing ABS relay
and relay base

Removing ABS relay

4
2
e
Caution:
Switch off ignition, disconnect and insulate the
ground (earth) strap.
•
Remove cover (1) from ABS control unit, press in
the lock with a screwdriver and pull the cover up.
•
Discard the old cover (1).
•
Detach lines (2) and discard nuts.
e
Caution:
Make sure the cable is not at an angle or its insula-
tion may be damaged.
•
Pull off 2-pin plug (3).
•
Take out relay base (4).
•
Slacken off screws on relay base by app. 2 turns
with Torx T20.
•
Pull the relay off upwards.
1
3
RS340200

Installing the ABS relay

•
Insert the ABS relay with the FAG inscription
facing the detent hook.
•
Tighten the screws at the relay base.
•
Push the relay base into the relay housing, at the
same time pressing both engine cables into the
left cable entries on the relay housing (red at bot-
tom, black at top).
•
Attach black engine cable to left threaded pin
(M5) with crimp at back.
e
Caution:
Make sure the cable is not at an angle, or its insula-
tion may be damaged.
•
Attach 2-pin plug in correct position, pushing it
on fully and press the two wires into the center
(smaller) cable entries.
•
Push the two plugs for the connecting cable/
wiring harness onto the threaded pins with
the crimp at the front..
•
Press the two cables into the remaining free
cable entries.
•
Tighten the nuts.
e
Caution:
Always use new selflocking nuts.
•
Install a new cover (1).
e
Caution:
When sliding the cover on, make sure that all cables
are correctly located in their cable entries. Scrap
the old cover.
34.29