With cable junction block
•
Push back the protective rubber cap (1) at the
throttle and choke cables.
•
Turn adjusting screw (2) at the throttle and choke
cables to adjust play.
Choke cable play: ................. app. 1 mm (0.039 in)
Throttle cable play:............... app. 1 mm (0.039 in)
•
Turn adjusting screws at the left and right throt-
tles to adjust play.
Throttle cable play:............. app. 2 mm (0.0787 in)
00.40
•
Connect the BMW Synchrotester,
BMW No. 13 0 800, to the vacuum
bores of the throttles..
•
Ride the motorcycle until the engine is warm,
2
or alternatively allow it to warm up at a
1
standstill for approx. 10 minutes.
e
Caution:
Engine must not run for more than 20 minutes when
motorcycle is not moving.
Oil temperature: ...............................at least 90 °C
(FID: at least 5 bars)
•
Switch on the Synchrotester and select the bar
RT000080
chart with maximum resolution.
L
Note:
If the differences between the individual
columns are very large (greater than 5 mm), switch
to graph display and compare the cylinders; carry
out fault diagnosis if necessary.
See BMW Synchrotester diagnosis instructions.
a
RT000070