Network Info - Qvis Iapollo SMART NVR User Manual

4.5.7

Network Info

In this interface, you can perform network tests, analyse the results from the tests, and view
network load information.
4.5.7.1 Network Test
Network test interface is shown as in Figure 4-16.

Destination IP: Please input valid IPV4 address and domain name.

Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate. You can also view the network status, which
will either be displayed as 'OK', 'Bad', 'No connection', etc.

Network Sniffer Packet backup: Please insert USB2.0 device and click the Refresh
button, you can view the device on the following 'Device Name' dropdown box. You can
use the dropdown list to select peripheral device. Click Browse button to select the snap
path. The steps here are the same as preview backup operation.
You can view all connected network adapter names (including Ethernet, PPPoE, WIFI, and 3G)
within the main list table panel. To begin Sniffer, click the button:
Backup' column. Click the grey stop button to stop. Please note system cannot Sniffer several
network adapters at the same time. After the Sniffer function starts, you can exit to implement
corresponding network operations such as login in to the Web, monitor, etc. Please go back to
Sniffer interface to click
file is named after "Network adapter name+time". You can use software such as 'Wireshark'
(Download from http://www.wireshark.org/) to open the packets on the PC for a professional
engineer to anaylse and solve complicated problems.
© Copyright Qvis ®. All documentation rights reserved.
stop Sniffer. System can save the packets to the specified path. The
Figure 4-16
within the 'Sniffer Packet
22