Qvis Iapollo SMART NVR User Manual page 55

4.6.5.13 Auto register
This function allows the device to auto register to your specified proxy. With this way, you can use
the client-end to access the NVR via the proxy. Here the proxy has a switch function. In the
network service the device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
1. Please set the proxy server address, port, and sub-device name at the device-end. Also
enable the auto register function, the device is able to auto register to the proxy server.
The setup interface is shown in Figure 4-52.
2. The proxy server software is developed from the SDK. Please open the software and input
the global setup. Please make sure the auto connection port here is the same as the port
you have setup in the previous step.
3. Now you can add the device. Please do not input default port number such as the TCP
port in the mapping port number. The device ID here shall be the same as the ID you input
in Figure 4-52. Click Add button to complete the setup.
4. Now you can boot up the proxy server. When you see the network status is 'Y', it means
your registration is OK. You can view the proxy server when the device is online.
Important: Do not input network default port such as TCP port number.
Important: The server IP address can also be domain. But you need to register a domain name
before you run proxy device server.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-52
48