Qvis Iapollo SMART NVR User Manual page 62

4 channel 4poe network video recorder
Table of Contents

Advertisement

Alarm output: when an alarm is triggered, system enables peripheral alarm devices.
Latch: when motion detection has been detected, the system auto delays detecting for a
specified time. The value ranges from 1-300(Unit: second)
Show message: System can pop up a message to alert you in the local host screen if you
have enabled this function.
Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you have enabled this function.
Send email: System can send out an email to alert you of when an alarm is triggered.
Record channel: Select the channel to activate recording function once an alarm has been
triggered. Please make sure you have set 'MD record' in the encode interface(Main
Menu->Setting->Schedule) and scheduled to record in the manual record interface(Main
Menu->Advanced->Manual Record)
PTZ activation: Here you can set the PTZ movement when an alarm has been triggered. The
System can go to a preset when there is an alarm. Click 'Select' button, you can see an
interface is shown as in Figure 4-65.
Record Delay: System can delay the record for specified time after alarm has ended. The
value ranges from 10s to 300s.
Tour: Here you can enable a tour function when an alarm is triggered. System one-window
tour. Please go to chapter 5.3.9 to display tour interval setup.
Snapshot: You can enable this function to take a snapshot of an image when motion detect
alarm is triggered.
Please highlight icon
please click the save button, system goes back to the previous menu.
Note: In motion detection mode, you cannot use copy/paste to set channel setup since the video
in each channel may not be the same.
In Figure 4-60, you can left click mouse and then drag it to set a region for motion detection. Click
Fn to switch between arm/withdraw motion detection. After setting, click 'Enter' key to exit.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-65
to select the corresponding function. After all the setup are complete
55

Advertisement

Table of Contents
loading

Table of Contents