Qvis Iapollo SMART NVR User Manual page 122

6.4.2.7 PTZ
PTZ interface is shown in Figure 6-42
Note: before operation, please make sure you have set the speed dome address and made sure
the NVR & speed dome connection are OK.
Please refer to the following sheet for detailed information:
Parameter Function
You can select monitor channel from the dropdown list. .
Channel
Select the corresponding dome protocol.(such as PELCO-D)
Protocol
Set corresponding dome address. Default value is 1. Please note your
Address
setup here shall comply with your dome address; otherwise you
cannot control the speed dome.
Select the dome baud rate. Default setup is 115200.
Baud
Rate
Default setup is 8. Please set according to the speed dome dial switch
Data Bit
setup.
Default setup is 1. Please set according to the speed dome dial switch
Stop bit
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.
© Copyright Qvis ®. All documentation rights reserved.
Figure 6-42 PTZ
115