Qvis Iapollo SMART NVR User Manual page 48


Default: UPNP default port setting is the HTTP, TCP and UDP of the NVR.

Add to the list: Click this to add the mapping relationship.

Delete: Click this to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure 4-39.
Important:
When you are setting up the router's external port, please use the 1024~5000 port. Do not
use well-known port 1~255 and the system port 256~1023 to avoid any conflict.
For the TCP and UDP, please make sure the internal port and external port are the same to
guarantee the proper data transmission.
4.6.5.8 WIFI Setting
You can view the WIFI connection status in the Network Setting interface (see Figure 4-40). You
can also view the current connection status and IP address if there is a connection.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-39
Figure 4-40
41