Table of Contents
Advertisement
6.4.4.2 Auto register
The auto register interface is shown in Figure 6-57. You can set the server IP and port if you want
to use the auto register function. After the device registered to the server, you can access the
device after the client-end connected to the server.
Figure 6-57 Auto register
6.4.4.3 Mobile Config
The mobile setup interface is shown as in Figure 6-58. Here you can activate or disconnect device
with a 3G connection, such as telephone, mobile phone or the alarm activated message number.
Figure 6-58 Mobile Setup
© Copyright Qvis ®. All documentation rights reserved.
128
Advertisement
Table of Contents
