Appendix G. Fibre Channel Adapter Event Logs; Fibre Channel Adapter Error Codes - IBM TotalStorage NAS 300 User Reference

Appendix G. Fibre Channel adapter event logs

You can view event logging for the Fibre Channel adapter for troubleshooting
problems using the event viewer. The detailed event code is displayed at offset 34
(hex). Table 47 gives a list of detailed event codes for the adapter. For some of the
event codes, additional data will be recorded in the least significant 16 bits of the
longword. Additional data might also be recorded in the longword at offset 10 (hex).
Certain codes will be logged only if you set a Fast!UTIL parameter to enable
additional event logging. These codes are indicated by an asterisk (*). By default,
these events are not logged.
If an error occurs that is not listed in Table 47, contact the IBM Support Center (1
800 426-7378 in the U.S.). In all other countries, contact your IBM reseller or IBM
marketing representative.
© Copyright IBM Corp. 2002
Table 47. Fibre Channel adapter error codes
Event code More data
offset 34h offset 10h
4002xxxx yyyy00zz
4005xxxx Yyyy00zz
4005xx6F yyyyyyzz
* 80010000 00000000
8003xxxx yyyyzzzz
8004xxxx yyyyzzzz
* 80100000 0000xxxx
* 80110000 xxxxyyzz
80120000 00000000
80130000 0000xxxx
Description
Host interface error: xxxx =
mailbox1; yyyy = mailbox2; zz =
command
Mailbox command error: xxxx =
mailbox1; yyyy = mailbox2; zz =
command
Login Fabric port mailbox command
error: xx = adapter; state yyyyyy =
port id; zz = loop id
Reset detected
RISC request queue transfer error:
xxxx = mailbox1; yyyy = mailbox2;
zzzz = mailbox3
RISC response queue transfer error:
xxxx = mailbox1; yyyy = mailbox2;
zzzz = mailbox3
LIP occurred: xxxx = mailbox1
Link up 2200: xxxx = current ISP
connection mode (0 = Loop, 1 =
P2P); yy = ISP connection option 0
= Loop, 1 = P2P, 2 = Loop->P2P, 3
= P2P->Loop; zz = starting loop id
for remote devices. 2100: xxxx =
0000; yyyy = 0000
Link down error
LIP reset occurred: xxxx = mailbox1
Suggested action
Hardware DMA
error: replace
adapter
Normally indicates
loop down, check
all cabling
Normally indicates
loop down, check
all cabling
Not logged during
normal operation
Hardware error:
replace adapter
Hardware error:
replace adapter
Not logged during
normal operation
Not logged during
normal operation
Not logged during
normal operation
Not logged during
normal operation
169