Replacing The Battery - IBM TotalStorage NAS 300 User Reference

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following safety guidelines.
CAUTION:
<2–16> When replacing the lithium battery, use only IBM Part Number
33F8354 or an equivalent type battery recommended by the manufacturer. If
your system has a module containing a lithium battery, replace it only with
the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: For translated versions of this safety notice, refer to Translated Safety
Note: In the U.S., call 1 800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a correct manner. To
order replacement batteries, call 1 800-772-2227 within the United States.
Before you begin:
v Review the information in the section "Before you begin" in Chapter 3 of the
v Attach a monitor and keyboard.
To replace the battery:
106
NAS Gateway 300 User's Reference
!
Notices, which is on the publications CD-ROM that was shipped with your
appliance.
hardware installation guide that came with this appliance, and any special
handling and installation instructions supplied with the replacement battery.
Note: After you replace the battery, you must reconfigure your appliance and
reset the system date and time.
1. Shut down (see "Shutting down and powering on the NAS Gateway 300" on
page 87) the appliance and peripheral devices, and disconnect all external
cables and power cords.
2. Remove the cover (see "Removing the cover" in Chapter 3 of the hardware
installation guide that came with this appliance).