Releasing The Battery; Inserting The New Battery - IBM TotalStorage NAS 300 User Reference

Figure 10. Releasing the battery
Figure 11. Inserting the new battery
10. Replace the adapter-support bracket (see "Adapter-support bracket" in Chapter
11. Reinstall the engine cover, and connect the power cords and external cables.
12. Power on the appliance.
13. Start the Configuration/Setup Utility program and set configuration parameters:
108
NAS Gateway 300 User's Reference
8. Insert the new battery:
Note: Ensure that the polarity of the battery is correct. The positive (+) side
must face up.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks under the battery clip,
as shown in Figure 11.
9. Reinstall the adapters and plastic dividers in the same slots from where they
were removed, and reconnect any internal cables that were disconnected (see
"Adapters" in Chapter 3 of the hardware installation guide that came with this
appliance).
3 of the hardware installation guide that came with this appliance).
Note: You must reinstall the air-baffle assembly when you reinstall the
adapter-support bracket. Make sure that no cable is under the
adapter-support bracket or interferes with the center fans.
Important: To ensure correct cooling and engine operation, you must keep
the air-baffle cover closed.
Note: Wait approximately 20 seconds after you plug the power cords of your
appliance into electrical outlets for the power button to become active.
v Set the system date and time
v Set the power-on password
v Reconfigure your appliance