3. Lift the adapter-retention clip on top of the adapter-support bracket (see
"Adapter-support bracket" in Chapter 3 of the hardware installation guide that
came with this appliance).
4. Remove all of the full-length adapters and plastic dividers (refer to "Adapters"
in Chapter 3 of the hardware installation guide that came with this appliance).
Attention:
Note the location of the adapters. You must replace each adapter
in the same slot from which it was removed.
Note: You do not need to unplug the internal adapter cables.
5. Locate the battery (connector BH1) on the system board using Figure 9.
1
Battery
Figure 9. Replacing the battery
6. Remove the plastic cover on the system board.
7. Remove the battery:
a. Use one finger to press the top of the battery clip away from the battery
until the battery releases upward from the socket as shown in Figure 10 on
page 108.
b. Lift and remove the battery from the socket.
1
10
Chapter 8. Troubleshooting
107