Running Adapter Diagnostics; Alacritech 100X4 Quad-Port Server Accelerated Adapter Led Definitions - IBM TotalStorage NAS 300 User Reference

Table 12. Alacritech 1000x1 Single-Port Server and Storage Accelerated adapter troubleshooting chart (continued)
Alacritech 1000x1
Single-Port Server and
Storage Accelerated
adapter problem
Point-to-Point Tunneling
Protocol (PPTP) does not
work through the Alacritech
1000x1 Single-Port Server
and Storage Accelerated
adapter interface.
When uninstalling the
Alacritech TCP Fast-path
driver, an error message
appears with the message:
"Could not uninstall the
Alacritech TCP Fast-path
driver component. The error
is 0x800F020B"
Alacritech 100x4 Quad-Port Server Accelerated Adapter
Table 13 displays the LED definitions for the Alacritech 100x4 Quad-Port Server
Accelerated Adapter LED definitions.
Table 13. Alacritech 100x4 Quad-Port Server Accelerated Adapter LED definitions
LED
LNK
ACT

Running adapter diagnostics

This section describes how to test the adapter using the diagnostics.
Note: Running the adapter diagnostics will disrupt the network connection.
Ethernet adapters
This section explains how to test Ethernet adapters.
Suggested action
PPTP connections cannot be established through a SLIC TCP/IP Offload-enabled
interface. In order to use PPTP with the Alacritech 1000x1 Single-Port Server and
Storage Accelerated adapter, disable SLIC TCP/IP Offload on the interfaces through
which you want to establish a PPTP connection. To disable the SLIC TCP/IP Offload,
complete these steps:
1. From the start menu, open the Network & Dial-up Connections folder located in
the Settings menu.
2. Double-click the LAN connection of the interface you want to disable TCP Offload.
3. Click the Properties button. Clear the box labeled Alacritech TCP Fast-path driver.
Click OK.
4. Restart the engine.
No corrective action is necessary.
Indication
Off
Green
Amber
Off
Flashing amber
Meaning
Either the adapter or the switch (or both) are not
receiving power, or the cable connection between them
is faulty.
The adapter and switch are receiving power. The cable
connection between them is good. A 100 Mbps link has
been established.
The adapter and switch are receiving power. The cable
connection between them is good. A 10 Mbps link has
been established.
The adapter is not sending or receiving network data.
The adapter is sending or receiving network data.
Chapter 8. Troubleshooting
103