Configuring The Public Local Area Connection - IBM TotalStorage NAS 300 User Reference

10. Click Advanced, and select the WINS tab.
11. Select the Disable NetBIOS over TCP/IP radio button.
12. Click OK.
13. Select Yes at the prompt to continue using an empty Primary WINS address.
14. Click OK on the Internet Protocol (TCP/IP) Properties panel.
15. Click OK on the Local Area Connection Properties (Private) panel.
16. Rename the connection to Private.

Configuring the public local area connection

Note: While the public network adapter's IP address can be automatically obtained
To configure each public local area connection, perform the following steps on each
node:
1. Right-click My Network Places, then click Properties.
2. Select a Local Area Connection.
3. To rename the connection, click Rename, and then type (for example) Public 1,
4. Use the networking information in Table 1 on page 8 to enter the networking
34
NAS Gateway 300 User's Reference
Link speed and Duplex
5. Click OK.
6. If prompted to restart the node, select No.
7. In the Properties panel for the integrated Ethernet controller connection, select
Internet Protocol (TCP/IP) from the components section, and click
Properties.
8. The default IP addresses should be:
v 10.1.1.1 for the first node
v 10.1.1.2 for the joining node
If they are not, it is recommended that you set them to those values.
9. Ensure a Subnet Mask of 255.255.255.0.
if a DHCP server is available, this is not recommended for cluster nodes. It
is strongly recommended that you set static IP addresses for all network
adapters in the cluster. If IP addresses are obtained through DHCP, access
to cluster nodes could become unavailable if the DHCP server goes down.
When you perform this step, the connection that uses the integrated Ethernet
controller is the private connection. The other active connection is the public
connection. Use that other active connection for this step and the next step.
and press Enter. Ensure that local area connection names are unique.
When you perform these renaming steps for the joining node, ensure that the
local area connection name for each physically connected network is identical
on each server. See Table 3 on page 35 for a further example.
addresses:
a. Right-click My Network Places.
b. Click Properties.
c. Right-click the Public icon, and then click Properties.
d. Select Internet Protocol (TCP/IP).
100 Mbps / Full Duplex
1000 Mbps / Full Duplex