Stand-Alone Tssc And Customer Network Ethernet Connections; Stand-Alone Fibre Channel Connections - IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual

Table 7. Stand-alone TSSC and customer network Ethernet connections (continued)
Action From
Verify existing Port 2
connection
Procedure
1. Label and connect Ethernet cables (Cat 5e or higher) according to Table 7 on
2. Go to "Stand-alone fibre channel connections."

Stand-alone fibre channel connections

About this task
Important:
This document references IBM DS4700 disk controllers (1814 70H) and IBM EXP810
disk expansion modules (1812 81H) in many of the hardware installation figures,
examples, and procedures.
In addition to the IBM DS4700 disk controller, the TS7650G also supports the
DS5000 disk controller and the XIV disk controller. If the customer has elected to
use disk storage components other than the IBM DS4700 disk controllers (1814
70H) mentioned above, the figures, examples, and procedures in this document
will not apply to the configuration on which you are working. Therefore, it is
suggested that you determine the make and model of the disk storage components
in use and, if necessary, obtain the related product documentation before you begin
installation of the gateway.
The RAS code no longer sends call home packages for problems with any of the
disk storage products attached to the gateway including DS4700, DS5000, and XIV.
However, if the IP address of an SMTP server is provided during RAS package
configuration, the disk storage subsystems that communicate with the RAS
package (which includes DS4700 and DS5000 if they have firmware levels
supported by RAS) will send problem reports to the customer via email.
30
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
On Device
TSSC
page 29.
Notes:
v Depending upon the model of the TSSC and TSSC network switch being
used, the port layout may differ from what is shown in Figure 9 on page 29.
If so, make the cable connections according to the port number assignments
specified in Table 7 on page 29, regardless of the position of the ports on the
TSSC or the switch. Refer to the IBM System Storage TS3000 System Console
(TSSC) Maintenance Information for detailed port information.
v Connection of the replication network cables is required only if the customer
is enabling the data replication feature.
To On Device/Location
Specified device Customer's Ethernet network