Collating Copies (Finisher) - Canon imageRunner 400 Reference Manual

Collating Copies (FINISHER)

When [FINISHER] is selected, copied papers can be collated into copy sets or groups of
the same page and output.
NOTICE
If the feeder is not installed, this function can not be used.
When "Collate" is set:
Copies are automatically collated into sets arranged in page order, and output onto the
trays as follows.
Originals
Three sets
of copies
specified
1
2
3
4
When "Group" is set:
All copies of the same original page are automatically collated and grouped together,
and output onto the trays as follows.
Originals
Three sets
of copies
specified
1
2
3
4
When "Staple" is set:
Copies are automatically collated into sets arranged in page order, output onto the
trays as shown below, and then automatically stapled.
Originals
Three sets
of copies
specified
1
2
3
4
When none of the above (Collate, Group or Staple) are set:
All copies are output into the top tray as follows.
Originals
1
2
3
4
When "Rotate" is specified
When the same size of copy papers are placed both vertically and horizontally, the copies
are collated into sets in page order, and output one set at a time in alternating directions.
NOTICE
Only sizes LTR, STMT can be selected.
When Staple is selected, Memory Collating (Rotate) cannot be performed.
Copy set 1 Copy set 2
4
3
2
1
Grouped copies Grouped copies
of page 1 of page 2
1 2
1
1
Only possible with Finisher C1, Saddle Finisher C2 or Finisher E1
Copy set 1
Copies
Copy set 3
4 4
3
2
1
Grouped copies
of page 3
3
2
3
2
3
Copy set 2 Copy set 3
3
2
1
Grouped copies
of page 4
4
4
4
2–39