Table of Contents
Advertisement
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Modify Settings > Raster
NOTE: The Modify Settings > Raster selection is only
available on the menu tree when an AL5010 unit with the
raster option.
Selection
Definition
Specify the upper limit of the laser from -20-degrees to +20
Upper Sweep
degrees from 0-degrees.
Lower Sweep
Specify the lower limit of the laser from -20-degrees to +20
d
egrees from 0-degrees.
Oscillating
Specify the frequency at which the vibrating vane (mirror) will
oscillate between 0 and 10 Hz. This is the speed of the mirror
Frequency (Hz)
oscillation with 0 being effectively stopped and 10 oscillating the
fastest.
NOTE: The laser will sweep between the
specified upper and lower values.
Example 1: If the upper value is set at -5-
degrees and the lower value is set at -10-
degrees, the laser will sweep the 5-degree range
specified below 0-degrees.
Example 2: If both the upper and lower values
are set at the same value, the laser will stay on
that fixed value without sweeping.
Advertisement
Table of Contents
