Datalogic AccuLazr AL5010 Product Line Manual page 104

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
NETWORK LED during Normal Operations
Mode Description
Single TCP/IP
Solid
NOTE: If both Host 1 and Host 2 are used, the LED will be
solid
Off – No host connection.
NOTE: If UDP messaging is used (unconnected messages)
the Network LED will be off.
EtherNet/IP Solid
Flashing
Flashing
Controller/Client Controller
Solid
same group number have been found.
Flashing
number have NOT been found
Client
Solid
group number.
Off – Not connected to a controller with the same group
number.
NOTE: The mode indicated by the Network LED is dependent on the AL5010
configuration you are using. Ethernet/IP is the highest priority, Single TCP/IP mode
operation is the lowest.
Using Control Panel Buttons to Check Normal Operations
Ref Button
Restore to Scan
Head
Backup to
Mounting Base
Test /Diagnostic
(Laser Shutoff)
REMEMBER: AL5010's control panel buttons can be enabled / disabled
through the use of the browser-based setup application.
(See Modify > AL5010 Configuration, Enable AL5010 Control Panel
Buttons.)
GREEN
– AL5010 connected to a host.
GREEN
if either port is connected.
GREEN – AL5010 made a connection to the PLC
GREEN – No connection made with the network
RED
– Lost network connection
GREEN – The correct number of client(s) with the
RED – All the client(s) with the same group
GREEN – Connected to a controller with the same
Description
Restores parameters from Mounting base to Scan
Head
 Button must be pressed twice to initiate action.
 See page 99 for procedure.
Downloads parameters from Scan Head to Mounting
base
 Button must be pressed twice to initiate action.
 See page 99 for procedure.
 Enables the AL5010 test mode.
(Test mode can also be selected remotely using
Tools > Commands > Test Mode.)
 Use to perform laser shutoff. (See page 107.)