Table of Contents
Advertisement
36
Mechanical Installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To install your optional I/O module(s):
1. Remove the cover to gain access to the printed circuit board.
2. The I/O modules may be plugged into locations I/O 1 through I/O 4.
These locations run left-to-right, as shown on the circuit board
silkscreen.
3. Plug the appropriate I/O module directly into the interface module's
circuit board.
4. Using a screwdriver, secure the I/O module by tightening the captive
screw (that goes through the module) into the circuit board. DO NOT
over-tighten screw.
Installing an I/O Module
AccuLazr
AL5010 Product Line Manuals
™
Advertisement
Table of Contents
