Table of Contents
Advertisement
Modify Settings > Modulo Checks
Use the Modulo Checks screen to setup the user defined modulo checks for
any bar code symbologies that you have specified need them. If you selected
a User Defined Modulo Check while in the Modify Settings > Bar Codes
setup screen, you will need to define it on the Modulo Checks screen.
To set a user defined modulo check for a bar code:
If a bar code requires a User Defined Modulo Check as defined on the Bar
Codes page, go to the Modify Settings > Modulo Checks page.
1. Find the correct modulo check row (i.e., User Defined 1 through 5) for
the code.
2. Set the Factor.
3. Set a Divisor.
4. Select Remain, if required.
5. Select Right, if required.
6. Select Wrap, if required.
7. Repeat as necessary for all codes with a user defined modulo check.
8. Click Update.
0.
See also: Modify Settings > Modulo Checks in Appendix C.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Advertisement
Table of Contents
