Datamax E-Class Mark III Professional Operator's Manual page 18

4) Route the media through the External Media Slot in the rear of the printer. Pull out enough media
to exit the front of the printer. Adjust the Media Guides so they are lightly touching the edge of
the media.
5) If using Thermal Transfer media (ribbon) proceed to Section 2.4 Loading Ribbon. Otherwise close
the printer's Cover and press downward until latched.
6) Press the
The printer is factory set to use gap media. If using another media type (for example, continuous

media), printer setup must be reconfigured; see Section 3.4
12
button to advance the media (if the Fault Light is lit, see Section 3.7.)

External Media Slot

Media Guides

External Media Supply
.
Chapter 2 – Printer Setup