Datamax E-Class Mark III Professional Operator's Manual page 16

4) Pull out enough media to exit the front of
the printer. Adjust the Media Guides so
they are lightly touching the edge of the
media.
5) If using thermal transfer media (ribbon) proceed to Section 2.4 Loading Ribbon. Otherwise close
the printer's Cover and press downward until latched. Pro

Pro+ models are equipped with a Cover Release Latch. Press outward on the latch to release cover.
6) Press the
The printer is factory set to use gap media. If using another media type (for example, continuous

media), printer setup must be reconfigured; see Section 3.4
10
312
button to advance the media (if the Fault Light is lit, see Section 3.7.)

Cover
Cover Release Latch

(Pro+ models only)
.
Chapter 2 – Printer Setup