Datamax E-Class Mark III Professional Operator's Manual page 42

Advanced Entry Calibration (continued)
Step Action
button to exit the
Press the
current menu level.
Using the button, scroll to
PAPER SENSOR LEVEL (or if using
reflective media, REFL PAPER
N
LEVEL) and then press the
button.
Using the or
Paper value determined in Step M
and then press the
Using the button, scroll to GAP
SENSOR LEVEL (or, if using
reflective media, MARK SENSOR
LEVEL) and then press the
button.
O
Using the or
Gap (or Mark) value determined in
Step M and then press the
button.
Using the button, scroll to
EMPTY SENSOR LEVEL and then
press the button.
P
Set the Empty value determined in
Step M and then press the
button.
Press the repeatedly
the menu, select YES at the SAVE
Q
CHANGES prompt and then press
the button.
If the calibration attempt fails, try desensitizing the sensor as follows:
Go to MEDIA SETTINGS / SENSOR CALIBRATION / ADVANCED ENTRY / TRAN (or REFL) SENSOR GAIN

and lower the corresponding GAIN SETTING by one.
Exit the menu and save your changes. Test your media at the new setting. If necessary, repeat until a

usable Gain Setting is obtained.
36
Displayed Message
PAPER SENSOR LEVEL
button, set the
button.
GAP SENSOR LEVEL
button, Set the
EMPTY SENSOR LEVEL
to exit
No
>Yes
174
(0 - 255)
042
(0 - 255)
9
(0 - 255)
Save Changes?
Chapter 3 – Printer Operation
Comment
This is the Paper value.
This is the Gap (or Mark) value.
This is the Empty value.
Save Changes. The printer is
ready for use.